弱正交异性材料残余应力测量的声弹性方法

为了适应工程材料的残余应力无损测量的要求,本文将横波和纵波声弹性相结合,建立适用於弱正交异性材料的平面声弹性残余应力测量方法,并应用该方法及自行研制的横波换能器对焊接试件的二维残余应力进行了测试。     

On the dynamics of rings rotating with variable spin speed

This work investigates nonlinear dynamic response of circular rings rotating with spin speed which involves small fluctuations from a constant average value. First, Hamilton's principle is applied and the equations of motion are expressed in terms of a single time coordinate, representing the amplitude of an in-plane bending mode. For nonresonant excitation or for slowly rotating rings, a complete analysis is presented by employing phase plane methodologies. For rapidly rotating rings, periodic spin speed variations give rise to terms leading to parametric excitation. In this case, the vibrations that occur under principal parametric resonance are analyzed by applying the method of multiple scales. The resulting modulation equations possess combinations of trivial and nontrivial constant steady state solutions. The existence and stability properties of these motions are first analyzed in detail. Also, analysis of the undamped slow-flow equations provides a global picture for the possible motions of the ring. In all cases, the analytical predictions are verified and complemented by numerical results. In addition to periodic response, these results reveal the existence of unbounded as well as transient chaotic response of the rotating ring.     

反射焦散线实验中斜入射光对应力强度因子测试精度的影响

本文用空间解析几何方法,推导了在一般非平行斜入射光条件下,裂纹体表面所形成的反射焦散线和初始曲线的方程.分析了倾斜入射光造成的焦散线畸变,给出了这种畸变造成的裂端应力强度因子测量误差的解析表达式.     

Direct interferometric measurement of streaming birefringence

The two refractive indices in the flow of a colloidal birefringent liquid are measured separately by means of a Mach-Zehnder interferometer. For a quantitative evaluation of the resulting interferograms it is not necessary to linearize the respective equations relating the refractive index distribution to the deformation velocity in the flow. Therefore it becomes possible to perform velocity measurements in the non-Newtonian flow range. An additional measurement of the mean flow rate enables one to determine the velocity field without the need of a calibration of the observed interference fringes.     

车-桥系统耦合振动响应的简便计算

依据振动理论推导出了二自由度模型车辆与桥梁系统竖向耦合振动微分方程，采用模态分析的离散化方法，将复杂的偏微分方程问题转化为变系数常微分方程问题，并将微分方程数值积分的Runge-Kutta方法引入到该时变系统的振动响应计算中，使复杂的耦合响应问题得到简便的解决。通过算例验证了该方法的有效性和简便性。该方法只需要直接数值积分，具有公式简单，编程方便，计算速度快等优点，特别适合于工程实际问题的计算，并且不仅适用于匀速运动车辆，也适用于变速运动车辆。     

A novel technique for time-resolved detection and tracking of interfacial and matrix fracture in layered materials

A novel experimental technique is developed for time-resolved detection and tracking of damage in the forms of delamination and matrix cracking in layered materials such as composite laminates. The technique is non-contact in nature and uses dual or quadruple laser interferometers for high temporal resolution. Simultaneous measurements of differential displacement and velocity at individual locations are obtained to analyze the initiation and progression of interfacial fracture and/or matrix cracking/delamination in a polymer matrix composite laminate system reinforced by graphite fibers. The measurements at multiple locations allow the speeds at which interfacial crack front (mode-I) or matrix cracking/delamination front (mode-II dominated) propagates to be determined. Experiments carried out use three-point bend configurations. Impact loading is achieved using a modified Kolsky bar apparatus with a complete set of diagnostics for load, deformation, deformation rate, and input energy measurement. This technique is used to characterize the full process of damage initiation and growth. The experiments also focused on the quantification of the speed at which delamination or damage propagates under primarily mode-I and mode-II conditions. The results show that the speed of delamination (mode-I) or the speed of matrix cracking/delamination (primarily mode-II) increases linearly with impact velocity. Furthermore, speeds of matrix failure/delamination under primarily mode-II conditions are much higher than the speeds of mode-I crack induced delamination under mode-I conditions.     

Variation in the wave resistance of an amphibian air-cushion vehicle moving over a broken-ice field

The nonstationary rectilinear motion of an amphibian air-cushion vehicle (AACV) on a water surface covered with finely broken ice is considered for various modes of velocity variation. The influence of the water depth, flotation parameters, and mode of motion on the wave resistance of the vehicle is analyzed. Maneuvering methods for increasing or decreasing the wave resistance of AACVs are proposed. __________ Translated from Prikladnaya Mekhanika i Tekhnicheskaya Fizika, Vol. 48, No. 1, pp. 97–102, January–February, 2007.     

无损残余应力测量及其新技术

简述及比较了主要的残余应力无损测量技术，重点为磁力法，并介绍一台新的磁力仪MAPS，且对MAPS及传统磁力仪作了比较，同时以X射线及中子衍射得到的结果验证了MAPS的可靠性，也介绍了文献上较少见的火车钢轨残余应力分布图。     

TiB2增强Al2O3陶瓷刀具高速干切削摩擦磨损性能

采用TiB2增强Al2O3陶瓷刀具对淬硬钢进行高速干切削试验,利用切削高温作用下的摩擦化学反应,在刀具表面原位生成具有润滑作用的反应膜,从而实现Al2O3/TiB2陶瓷刀具的自润滑.结果表明:低速干切削时,Al2O3/TiB2陶瓷刀具的磨损机制主要表现为粘着磨损和磨料磨损;而在高速干切削时,刀具的磨损机制主要表现为氧化磨损,刀具表面经由氧化反应生成具有润滑作用的反应膜而起到固体润滑作用,从而使刀具的耐磨性能提高,随着TiB2含量和切削速度的增加,反应膜的减摩抗磨作用增强;而在切削区通入氮气时,由于刀具表面氧化膜形成受阻,刀具的抗磨能力有所降低.